top of page

Draft Electricity Policy 2026: will demand charges favour batteries?

Writer: Vaultus
Vaultus
Jan 19
4 min read

Updated: 3 days ago

From our archive: we wrote this note after the week shown above, as part of our back catalogue. For anything newer, see the latest posts in this section.


If adopted, yes. The Ministry of Power's draft National Electricity Policy 2026, released on 20 January 2026, proposes that tariffs recover fixed costs gradually through demand charges, and that tariffs reflect the full cost of supply. A battery that trims your site's highest draw and shifts use away from costly hours is worth more under that kind of bill. It's still a draft, and states set the actual tariffs.


The Storage Brief, week of 19 January 2026


What changed

On 20 January 2026 the Ministry of Power issued the draft National Electricity Policy 2026 for comment. Once final, it will replace the 2005 policy, All India Radio News reported. Outlook Business reported that comments are due within 30 days. The draft proposes recovering fixed costs gradually through demand charges, and indexing tariffs so they rise automatically each year when a state commission issues no tariff order. A commentary by an IIT Kanpur professor notes the draft also says rooftop solar with storage should be promoted, power purchase cost increases should pass through to consumers monthly, and commissions may free distribution companies (DISCOMs) from the duty to supply consumers of 1 MW and above. On 21 January the Power Minister said the coming Electricity Amendment Bill will also bring in cost-reflective tariffs, PTI reported.


Why it matters

Most factories and hospitals pay two kinds of charge. One is for energy, in kWh. The other is for capacity, usually set by the highest kVA the site draws in the month. Today much of the DISCOM's fixed cost hides inside the energy rate. Move it into the demand charge, as the draft proposes, and the bill starts to punish short spikes.


A battery is very good at one thing: covering a 30-minute spike so the meter never sees it. Take an example: a factory that normally runs at 800 kVA but hits 1,000 kVA for half an hour when two furnaces start together. If a battery carries that spike, the month's billed demand drops by 200 kVA (our calculation: 1,000 minus 800 = 200 kVA). One short event sets the charge for the whole month, so one avoided event changes the whole month's bill.


The second change is timing. Monthly pass-through of power purchase costs means your per-unit rate can move every month, rather than once a year. If states follow the policy with higher evening prices, the gap between cheap daytime power and costly evening power widens. That gap is what pays for a battery's daily cycle, on top of the backup it gives when the grid fails. For lenders, a site whose battery earns its keep every day is a steadier payer than one whose battery only waits for outages.


What it means for you

  • Sites: Find out what share of your bill is demand charge today and when your monthly peak happens. That's the number this policy would move.

  • Battery makers: Size offers around the site's peak profile as well as its backup hours. Show the demand-charge effect from real meter readings.

  • Lenders: Ask whether a battery's monthly payment rests on backup alone or also on bill savings. Policy changes like this one affect the second.


The number

₹6.73 per unit: the average cost of supply across states, as cited by the Power Ministry on 21 January. Source: PTI via Outlook Business, 21 January 2026.


What to do now

  1. Pull twelve months of bills and split each into energy, demand and other charges.

  2. Ask your DISCOM or meter vendor for 15-minute load readings, and mark when your monthly peak occurs.

  3. If you want to comment on the draft, check the ministry's notice for the address and file within the 30-day window.


What we don't know yet

  • How fast states would shift fixed costs into demand charges, and for which consumer groups.

  • Whether the duty-to-supply exemption for 1 MW-plus consumers changes the backup they need.

  • What the final policy and the Amendment Bill will actually say.


Questions we get asked

Q: Will the draft National Electricity Policy 2026 change my electricity tariff right away? A: No. It's a draft central policy. State commissions set tariffs, and they would need to act on it. Check with your DISCOM.


Q: What is a demand charge on an industrial electricity bill? A: A monthly charge based on the highest load your site draws, usually in kVA, regardless of how many units you use.


Key facts

  • Document: Draft National Electricity Policy 2026

  • Issued by: Ministry of Power

  • Date: 20 January 2026

  • Status: draft (comments were due within 30 days; SolarQuarter reported the deadline was later extended to 19 March 2026)

  • Applies to: national electricity policy, replacing the 2005 policy; state commissions set actual tariffs

  • What it means for business batteries: if states follow it, demand charges and peak pricing would make a battery that trims peaks worth more.


Sources


Keep reading





Vaultus puts business batteries on a monthly plan. The battery maker installs and maintains the system, the site pays monthly, and the contract sets how much backup it gets. Send your last 12 months of electricity bills and diesel records to contact@vaultus.io, or run your own numbers with the site calculator.

bottom of page