What the demand charge and ratchet really cost you

Updated: 16 hours ago
Updated 17 November 2026: we replaced the illustrative rates with Uttar Pradesh's 2026-27 tariff and Delhi and Haryana rules, corrected the source for the draft policy, and added why spikes need power more than battery size, questions for your DISCOM, and common mistakes.
The demand charge bills your site for the highest load it draws in a month, not for the units it uses. Three rules make it costlier than it looks: a floor that bills a share of your contract demand even in quiet months, a penalty when load passes contract demand, and, in some tariffs, a ratchet that carries one bad month into the next eleven. Under Uttar Pradesh's 2026-27 rates, one 20-minute spike in our example costs ₹1.2 lakh in a month, and ₹2.4 lakh where a ratchet applies.
The Storage Brief, Bill lines explained, 6 November 2026
Key dates
2 Jul 2026: date of Uttar Pradesh's 2026-27 tariff order, with the demand rules used below. Source
25 Mar 2026 (reported): Haryana's regulator signs a 2026-27 tariff order keeping tariffs unchanged. Source
21 Jan 2026 (draft): The draft National Electricity Policy 2026 is released for comment, Down To Earth reported. Source
How demand is billed
A business on a high-tension supply pays for capacity in rupees per kVA (kilovolt-ampere, the unit of demand) each month. Contract demand is the kVA you agreed with your DISCOM. The meter records your maximum demand, usually as the highest average over a short block of minutes. Your tariff order or supply code sets the block length, so check it.
Billing demand is rarely just that recorded peak. Here is how three regulators that cover NCR sites set it.
Uttar Pradesh. Billable demand is "the actual maximum load / demand as recorded by the meter" or 75% of contracted demand, "whichever is higher". Large industry (HV-2) at 11 kV pays ₹300 per kVA a month. Above contracted load, the general provisions levy a charge "equal to 200% of the normal rate apart from the normal fixed / demand charges", for most categories (UPERC 2026-27 order).
Delhi. DERC's FY 2019-20 schedule levies fixed charges on billing demand. Where maximum demand exceeds sanctioned load or contract demand, "a surcharge of 30% shall be levied on the fixed charges corresponding to excess load", for that billing cycle only. Its industrial rate was ₹250 per kVA a month (DERC schedule). Delhi's prevailing tariff order is dated 30 September 2021, DERC said in August 2026, so check your current rate.
Haryana. Fixed charges for industry are ₹290 per kVA a month, PTI reported, levied on sanctioned contract demand, an industry body told The Tribune. If that is your basis, peaks do not move the charge. Contract demand does.
A ratchet sets billed demand at no less than a share of the highest demand recorded in recent months, for example the previous 11. We did not find one in the UP and Delhi documents above. Check the billing demand clause in your own tariff order before you assume either way.
A worked example
Take a Ghaziabad factory on UP's HV-2 tariff at 11 kV, with a contract demand of 1,000 kVA and a normal peak of 740 kVA (an example).
A normal month. The 75% floor is 750 kVA, above the 740 kVA peak, so the site pays for 750 kVA: ₹2,25,000 (our calculation: 750 × 300).
The spike. Two chillers and a compressor start together and the meter records 1,050 kVA for 20 minutes. On our reading of the order, the site pays the normal charge on 1,050 kVA plus 200% of the normal rate on the 50 kVA excess: ₹3,15,000 + ₹30,000 = ₹3,45,000. That is ₹1,20,000 more than a normal month (our calculation: 1,050 × 300; 50 × 600).
If your tariff has a 75% ratchet (an example). The floor for the next 11 months rises to 787.5 kVA, 37.5 kVA above the old one. That adds ₹11,250 a month, or ₹1,23,750 over 11 months (our calculation: 0.75 × 1,050; 37.5 × 300 × 11).
One 20-minute event costs ₹1,20,000 without a ratchet and ₹2,43,750 with one (our calculation).
Spikes need power, not a big battery
Holding a spike is a different job from backup. To keep the factory above at 750 kVA through a 20-minute, 300 kVA spike, a battery must deliver about 300 kW for 20 minutes: around 100 kWh (our calculation: 300 × 20 ÷ 60, at a power factor near 1). The power rating matters more than the energy. A battery bought for a two-hour backup can often hold the peak as well, if its inverter is big enough and it is charged when the spike comes.
Why this line is likely to grow
The draft National Electricity Policy 2026 proposes "progressive recovery of fixed costs through demand charges", Down To Earth reported. It is a draft, and state commissions set the actual tariffs. If states follow it, more of the bill moves into the demand charge, and short spikes cost more.
What fixes it, in order
Find the spike. Ask your DISCOM for the meter's load profile, then match each monthly peak to what was running. Most spikes come from equipment starting together.
Stagger starts. Sequencing motors, chillers and compressors costs little and often removes the biggest spikes.
Check power factor. Demand in kVA is real power in kW divided by power factor. Raising power factor from 0.90 to 0.99 cuts kVA for the same load by about 9% (our calculation: 1 − 0.90 ÷ 0.99 = 0.091).
Hold the peak with a battery or load control. A battery sized for the spike's power keeps the meter below your target. It only saves money while your peak sits above the floor.
Then cut contract demand. Lowering it lowers the floor, but only once the meter shows you can stay under the new figure. Our guide to the demand trap explains why the order matters.
Common mistakes
Trimming a peak that sits below the floor. In UP, a peak under 75% of contract demand already bills at the floor.
Cutting contract demand before fixing spikes. The next spike then lands as an excess penalty.
Assuming a ratchet, or assuming none. Read the clause in your tariff order.
Sizing a peak battery in kWh only. The inverter's kW decides whether it holds the spike.
Letting peak work drain the backup reserve. If the same battery covers cuts, fix the reserve in kWh first.
What to ask your DISCOM
How is our billing demand worked out, and over what block of minutes is demand measured?
Does our tariff have a ratchet on past months' demand?
What penalty applies above contract demand for our category?
How do we lower contract demand, and how long does it take?
What to check on your own bills
Billing demand above recorded demand: the floor or a ratchet is setting your charge.
An excess demand line: a month your site went over contract demand. Note the date and what was running.
The same billed demand month after month: often the floor, or a ratchet from one bad month.
Questions people ask
Q: Why is my billed demand higher than my maximum demand? A: Most tariffs bill the higher of your recorded peak and a share of contract demand. In Uttar Pradesh that share is 75%. Some tariffs also look back at your highest demand in the previous 11 months.
Q: What is a demand ratchet on an electricity bill? A: A rule that sets your billed demand at no less than a share of the highest demand recorded in recent months. One high month can raise your bill for up to a year.
Q: What happens if I exceed my contract demand? A: You pay extra on the excess. In UP, a charge at 200% of the normal rate on top of the normal demand charge. In Delhi's FY 2019-20 schedule, a 30% surcharge on the fixed charges for the excess.
Q: Will a battery cut my demand charge? A: Only if your own peak sets the charge. If the floor or contract demand sets it, trimming the peak saves nothing until you also lower contract demand.
Sources
Tariff order for 2026-27, rate schedule and general provisions. Uttar Pradesh Electricity Regulatory Commission, 2 July 2026 (copy on PVVNL website).
Electricity tariff schedule for FY 2019-20. Delhi Electricity Regulatory Commission.
Order on relaxation of the FPPAS ceiling for June 2026. Delhi Electricity Regulatory Commission, 10 August 2026.
Haryana power regulator announces new tariff hikes. PTI via The Week, 2 April 2025.
Industry body questions hike in fixed power charges. The Tribune, 4 July 2025.
Haryana electricity commission keeps power tariff unchanged for 2026-27. The Tribune.
Centre proposes automatic tariff revisions in new draft electricity policy. Down To Earth, 21 January 2026.
Keep reading
**The whole bill: **Seven lines on your electricity bill that cost you money
**Before you cut contract demand: **The demand trap: why cutting contract demand can backfire
**Where policy is heading: **The draft National Electricity Policy and demand charges
Vaultus puts business batteries on a monthly plan. The battery maker installs and maintains the system, the site pays monthly, and the contract sets how much backup it gets. Send your last 12 months of electricity bills and diesel records to contact@vaultus.io, or run your own numbers with the site calculator.
